Free Crochet Kimono Model, Kylie Kimono – Crochet DreamzFree Crochet Kimono Model, Kylie Kimono
A crocheted lace kimono has been on my mind for a long time. I was expecting the weather to be warmer, so I could play with colors and light yarns.
The sample kimono was made from the Lionbrand Mandala yarn I collected when we visited the Lionbrand Yarn Studio in New York. I think I liked the way they came out. Pictures cannot capture the true beauty of colors.
The crochet pattern I used for this crochet pattern is easy to memorize and is perfect for spring or summer. Don’t you think?
2. Kimono consists of three parts: left panel, middle panel and right panel. The panels are continuous and do not work separately and are sewn together.
3. Even if you buy the same lot, every piece of Lion Brand Mandala yarn is wound differently. If you have purple on some skeins, others may be inside them. To make the right side of the kimono look the same as the left side, you may need to change colors to reflect color changes when making the right panel.
4. Kimono runs from one side to the other or from the arm hole to the arm hole. First, you work on a very long left panel, then add a back panel that is half the length, and then add a right panel that is the same length as the left.
1. Shows how the Kimono is made.
Crocheted Kimono Left Panel
With the larger Ch 210. If you want to increase the kimono length, you can add the multiples of 210 to this starting chain. Each 32 chains added will increase the length by 4-1 / 2 inches.
Line 1: hook 1 sc at 2nd ch and to end along each ch. 209 sc
Line 6: Ch 1, same as ch 1, 1 sc for next st, * (1 sc in next ch-1 field, 1 sc in next st), repeat * to last st (start ch) At the beginning of Ch-3, 1 sc. – 209 sc
Line 7: Ch 1, the same st as 1 sc, the next st with 1 st, and to the end of each st. – 209 sc
Repeat Lines 2-7 until you have 10 (10, 12, 12, 14, 14) wave lines and repeat Line 5. Repeat and Line 6 to complete the left panel. The last one, combine the back panel color after reading the note below. Translation.
The completed left panel is approximately 10 (10, 12, 12, 14, 14) inches wide.
If you use a single-color yarn, the following instructions do not apply, or you will not look for color changes on the right and left front of your kimono.
Before you start your back panel, make sure you set aside enough yarn in the right colors to make your right panel like the one on the left. Depending on the skein you have, you may need to separate the colors from it and wrap them in separate balls. Even though all the skeins of a motley skeins are the same color, they also noticed that there are some differences. So for my back panel, I took care to use the extra colors I had. The back panel is a very narrow piece that is half as long as the left panel, so you don’t need much yarn.
Line 1: When color is combined for the back panel, ch 1 (not counted as st), 1 sc in the same order as 1 st, 1 sc in the next st, and 104 sts. Translation. Sc- 105 sc
3. Line 1 ends between 2 sc of the previous Wave Line.
Note: Your last sc will be between 2 sc sts of the previous Wave Row as shown in pic 3 and will be in the middle of your left panel.
Repeat Lines 2-7 until you have 5 (6, 4, 5, 4, 5) wave lines on your back panel. Repeat Line 6 once more to complete the back panel and combine the color of your right panel. For your right panel, remember to reflect the colors of your left panel as much as possible.
The completed rear panel is 5 (6, 4, 5, 4, 5) inches wide.
Right Panel for M, L and 2XL Sizes
1. For these 3 sizes, your work rope will now be hemline.
2. When working on chains added for extension, you enter the rear overhangs of your chain to release the “V in of your chain, see figure 4 below.
4. Work by hitting the back of the chain
5. Chain to add an extension
6. Slide and tighten to the base of the last sc on the neck edge
Line 1: When the new color for the right panel is combined, ch 1 for each st, ch 1, 1 sc in the same st as ch 1, 1 sc, the chain made of ch 105 to extend this line as shown in pic 5, to the rear end of the 2nd hook 1 sc from the hook and from each blood to the tip, slide it to the sc base on the neck edge and align the sequence as shown in Figure 6. 209 sc
7. Line 2 runs from end of extension to back panel
Line 2: This line is processed from the end of your single crochet extension to the back panel as shown in pic 7. Combine the yarn with sc, ch 1 first and repeat Line 2 on the left panel. It extends to the length of the skirt.
Lines 3-7: Repeat Lines 3-7 of the left panel.
Repeat Lines 2-7 on the left panel until you have 10 (12, 14) wave lines for M (L, 2XL) dimensions. Repeat Line 6 to complete the right panel. Secure.
S, XL and 3 XL Size Right Panel
NOTE: Your working thread will be on the neck edge for these 3 dimensions.
8. Combine the right panel color on the neck edge and the extension chain
9. Continue sc working along the back panel
1st Row: The color of the right panel you just added to the corner of the rear panel, running as ch 105 as shown in picture 8, running backward for 1 sec in 2nd ch, continued until the end of each ch. along the back panel as shown in picture 9, 1 sec at each end. Translation. —–209 sts
2-4. Rows: Repeat lines 5, 6 and 7 of the left panel.
Now repeat steps 2-7 on the left panel until you have 10 (12, 14) wave lines for S (XL, 3XL) sizes. Repeat Line 3 to complete the right panel. Secure.
Continue All Sizes
Sew the edges of crochet Kimono
10. Fold the extensions forward and leave a space for the arm hole to join the edges
Fold the two extension pieces forward with the wrong side out as shown in figure 10. You can select the desired side as the wrong side. Sew the sides with a whip stitch, leaving a space for the arm hole, according to the following measurement chart.
Shoulder Sleeve Hole (inch)
Finishing the neck
Slide to the base of your left panel and draw an upward line along the edge of the left panel, along the back neckline, and along the down side of the right panel. Secure.
Hemline Rib Insertion
Row 1: Sit on the bottom of your kimono with a smaller hook and creamy DK weight, make a row sc along the skirt, 1 sc in each row, 3 chs against each ch-3 or 3 sc sts. Translation. There must be an equal number of sts at the end of this line.
Line 2: Ch3 (counted here and along as a dc), end up with 1 dc throughout each st. Translation.
I like to do it, but I do not understand the construction. Why is the back panel as short as half the other panels? What does it look like from behind? Short in the back and long in the front? TYLER.
The left and right panels extend from front to back. Back panel, well, just in the back. Please see Pic 1. Front and back of the same lengths. You can see the back view in one of the pictures above.
Nice vest or cardigan. I’m having trouble asking why you say a kimono. If you’re inspired by Japanese clothes, maybe you’re thinking about Haori, an open jacket worn over kimono.
I understand that fashion is intertwined with loose layers and called kimono, but if you name a design after a piece of traditional clothing from a legacy that doesn’t belong to you, you need to do your research and be sure to be respectful and name the part correctly.
Kristin, can you explain what’s the difference between a kimono and a haori? I don’t know what they are. I thought a kimono was just a slight Japanese version of the robe, so I’m obviously ignoring it and want to use appropriate terms to avoid disturbing anyone’s culture in the future. Thank you!
Look under the finished size. It gives you the width of your kimono from one arm to another. If the medium size is smaller than the width you need, go up one size. Since this is a loose pattern, you can be sure that it will look perfect even if you rise to a hook size.
oh I would love this riddle, a proper video or at least a wave pattern video. I’m going to try anyway, I wish me luck, if there was a video to match I would buy this model
Bringing macromeles of the 20th century here and now
I have to admit that until recently, the list of things I want to hang on my macrame walls will be at the end – when I grew up, it brought back memories of the moldy brown pieces I found in dozens of thrift stores. A particular macrame find – an owl made of twine – comes to mind. However, if you take the time to them, as proof that the flavors and trends have become a complete cycle (I’m betting the owl gets a nice penny in some old vintage boutiques right now) I’ve found myself with pleasure recently (not like that) Art.
Finally my example – my friend Jess recently bought the most beautiful wall hanging in Etsy (as you can see below) and it is full of neons to add a modern cool touch. After seeing this, I was desperate to know more about how these pieces were created – and I was very happy when Himo Art May agreed to stop running out. May did a great job of bringing the macro of the 20th century here and now (the last macromeles became perfect for me), and I was delighted that she decided to look at it – it turned out to be quite complicated – the process. It’s time to Improve your knotting skills, kids!
Things that you need:
- Wooden Dowel
- Wooden Breads
- Paint Brush
- Masking Tape
It can attach dowels to the wall – it uses a removable hook, because it’s a great way to not make holes in the wall.
It can cut the rope into 14 x 4 yard pieces and 2 x 5 yard pieces. It then begins tying the rope to the head nodes of the larvae and compiling the dowel with 5 yard pieces (one at each end) into a book.
The rest can continue with ropes.
Then it makes double half axle knot.
And it goes on and on.
By the end, May begins tying them diagonally across the ropes.
You can add wooden beads here and here before connecting the nodes.
Then each starts to connect the switch nodes using 4 ropes.
Can connect 8 of them.
And he brings them crosswise.
You can add more beads and bring the knots to the end.
It can then cut the ends of the rope.
Covers a portion of the dowel ends to paint and add a hint of neon (a woman from my own heart!)
Finally, he adds a watermelon pop to the end of the rope.
And there, hung a magnificent macrame wall. I can appreciate the work that goes into these pieces – not a craft for withered or ham!