How to knot a tie for Spanish bowlinehow – SPANISH bowline
Spanish Bowline combined by the same rope two adjustable rings contain. Initially, the savior of the people standing in two parts salvaged a draw would do for a recovery cycle was used as nodes.
as it is equal to prevent the load slipping on the loop as long as the Spanish Bowl can be used for various purposes. Considering loops that are directly connected with each other, you can adjust the size of the loop before putting it under pressure.
lay under the standing ends of the transition section, creating two switch turns 1 ..
anticlockwise, once left 2 .. clockwise loop twist, turn right once cycle.
3. Right left loop in the loop Tuck from front to back.
your hands from the front part of each cycle 4. Access. underpass underpass turn right hand and left hand turn at the left side to the right side.
Hand over the return passage extending through the lower loop that two side pull.
5. Dress loops and knot pull standing on end in the opposite direction.
I do not waste your traffic, your website have noticed non-monetary, you can earn additional money
because we have high-quality content each month. If you want to know how to earn extra money,
The main alternative to AdSense Ercanno: search
How to make macrame feather bag charms
- macrame yarn
- sharp scissors
- wood beads
I started using a piece of macrame yarn about 20 inches long. Fold it in half and place it on a clean surface as shown below.
You also need two pieces of yarn that are 8 inches long and folded in half.
One of the short sequences should be placed under the longer track as shown in the photo below. You can see the entire stream in my video above.
Place the other short rope on top and pass the ends over the tops. This is actually called a square node.
Pull all of them firmly and push the knot into the desired area so that the ends are the same length.
Then knot the base / end of the long string so that the square node can shift from the bottom.
After that you need to keep stacking square knots to get the length you want.
I made my feathers 10 to 12 inches long.
After completing the stacking of the square nodes, you need to remove and scan the macrame thread.
I like to do this part while watching a Netflix show. It calms me down. I know… Weird im
After going all over the macrame feather, you should end up with something you see below.
Now it’s time for a haircut to give a feather shape for wallet jewelry.
Finally you can slip a wooden bead on the end of the rope.
And here you have a very large macrame bag hammer.